100/10Base Patch and Cross over

Cabling-Design.com FREE cabling and networking Helpdesk

	Question by Nazmul Bhuiyan posted 29 Jan 2001
	100/10Base Patch and Cross over
I am new at the cabling process. I have found your site to be very informative and helpful. What I am looking for is the pinout diagram of a 10/100 Base patch and crossover cable. Could you please help me on this? Thanks in advance.
	Answer by Roman Kitaev posted 30 Jan 2001
Hi, Patch cords are wired straight-through (pin 1 to pin 1, pin 2 to pin 2 etc.) The cross-over cord for 10/100 Ethernet is shown at this link: http://www.cabling-design.com/references/pinouts/10-100base_t_crossover.shtml Best regards Roman Kitaev, RCDD
Click here to see the expert's profile

Back to the current page of questions | Back to all the questions

Back to Cabling-Design.com HELPDESK | Ask your question